Locks
Gas
Chassis parts
All Terrain Vehicle
Accessories AL-KO
Made-to-measure
Manoeuvring System, mover
Cable winches, electric
Pulleys
Mobile Winches
Recovery straps
Trailer tarpaulins
Weather Protection
Roof bike rack
Drawbar bicycle carrier
Rear bicycle carrier
Roof bars
Tailwagon
Awnings
Motorhomes
Awning tents
Travel awnings
Air technology
Television
Tableware
Batteries
Cutlery
Entertainment electronics
Pots and Pans
Refrigeration
Cable, plug, extension
Tables
Camping Chairs
Gas installation in camping vehicles (motorhome, caravan and outdoor)
From the gas cylinder to the open flame on the gas cooker: This gas route via pipe and hose installation can also be easily planned by DIY enthusiasts.
The first step is to decide which pipe cross-section should be used.
After all, not every mobile camping vehicle is the same and some are equipped with many appliances - such as a gas cooker, fridge, heater, barbecue, etc.
The question must therefore be clarified as to whether 8 or 10 mm pipe diameter should be used:
For 50 mbar gas systems, the diameter for gas pipes, hoses and all connecting parts is usually 8 mm.
However, modern vehicles today almost always have a 30 mbar system installed.
At a lower operating pressure of 30 mbar, however, it makes sense to increase the gas volume up to the distribution blocks in order to ensure a sufficient and constant supply to the individual consumers.
In this case, the connection from the gas tank (gas cylinder) to the distribution block must be made using a 10 mm gas pipe.
Please note that the supply from the distribution block to the individual consumers must still be 8 mm in diameter.
Quick-closing valve...
Distribution block type DSV
Quick-closing shut-off valve for 10/8 mm gas pipe
WITHOUT distributor block sticker (symbols for labelling such as heating, hob, refrigerator, etc.)
Connection: SRV 10 and SRV 8
Elbow union type W, 90...
Elbow union type W, 90 degrees, gas pipe
with union nut type M and cutting ring type D
EN ISO 8434-1 - EC
Material: galvanised steel
Selection according to gas pipe outer diameter 8mm or 10mm
Supply flap GOK Gas...
Gas outdoor socket for barbecue or external gas barbecue
Supply flap Variant white with lock for external gas connection
Plastic supply flap for gas supply outside the motorhome
Article features:
Liquid gas line: SKU x RST 8
Product dimensions: L210 x W88 x D35 mm
Installation dimensions: L157 x W67 x D50 mm
Body cut-out: 155 x 65 mm
Weight: 400 g
Straight screw...
Straight screw connection type G, gas pipe
with union nut type M and cutting ring type D
EN ISO 8434-1 - EC
Material: galvanised steel
Selection according to gas pipe outer diameter 8mm or 10mm
Gas pipe ø10mm steel...
Gas pipe 10 x 1 mm, galvanised 1.5 m
Precision steel pipe dia. 10 x 1 mm
Design: Supply pipe, galvanised (for gas installations in vehicles)
Delivery unit: 1 piece à 1.5 m length
Gas pipe ø8mm steel...
Gas pipe 8 x 1 mm, galvanised 1.25 m
Precision steel pipe dia. 8 x 1 mm
Design: Distribution pipe, galvanised (for gas installations in vehicles)
Delivery unit: 1 piece à 1.25 m length
2-Burner Hob/sink...
Cooker/sink combination with glass cover
Cooktop combined with sink
2-flame, with ignition safety device, sink on the right side.
- Stainless steel
- Top controls
- With ignition safety device
Weight: 6 kg
2-Burner Hob/sink...
Cooker/sink combination with glass cover
Cooktop combined with sink
2-flame, with ignition safety device, sink on the left side.
- Stainless steel
- Top controls
- With ignition safety device
Weight: 6 kg
Cutting ring fitting...
Straight screw-on fitting type GAI
Screw-on fitting for domestic cookers, multi-burner hobs with threaded pipe connection in caravans or campervans.
Inlet: Cutting ring fitting
Outlet: Female pipe thread, screw-in hole DIN 3852-2
Form Y without countersink, short version
- Fitting GAIL 8 x G1/2 galvanised
EN ISO 8434-1 - EC
Material: galvanised steel
Gas pipe outer diameter: 8mm
Gas cylinder valve GOK...
Gas cylinder valve type CGV, small butane cylinder, Campinggaz
Gas cylinder valve for connection to Campingaz butane cylinders up to 5 kg filling weight
- Actuating valve (open/closed)
- Safety blow-off valve: Release pressure 14 bar.
Material: brass
Weight: 155 g
Gas supply flap, GOK...
External gas feed for leisure vehicles as an installation kit
Practical set for connecting large external cylinders abroad or for winter camping
For 1 and 2 cylinder systems in parallel operation with an additional cylinder outside the vehicle
Ideal for stationary operation if large quantities of gas are required in the vehicle or if the vehicle's own gas tanks are too small for third-party cylinders:
Complete set for installation on the vehicle or as a bag to carry in the vehicle.
Double wall bracket...
Double wall bracket for gas tank cylinder ø300mm
Wall bracket with 2-fold tensioning strap for one ALUGAS gas cylinder
Weight: 2,5 kg