Locks
Gas
Chassis parts
All Terrain Vehicle
Accessories AL-KO
Made-to-measure
Manoeuvring System, mover
Cable winches, electric
Pulleys
Mobile Winches
Recovery straps
Trailer tarpaulins
Weather Protection
Roof bike rack
Drawbar bicycle carrier
Rear bicycle carrier
Roof bars
Tailwagon
Awnings
Motorhomes
Awning tents
Travel awnings
Air technology
Television
Tableware
Batteries
Cutlery
Entertainment electronics
Pots and Pans
Refrigeration
Cable, plug, extension
Tables
Camping Chairs
Gas installation in camping vehicles (motorhome, caravan and outdoor)
From the gas cylinder to the open flame on the gas cooker: This gas route via pipe and hose installation can also be easily planned by DIY enthusiasts.
The first step is to decide which pipe cross-section should be used.
After all, not every mobile camping vehicle is the same and some are equipped with many appliances - such as a gas cooker, fridge, heater, barbecue, etc.
The question must therefore be clarified as to whether 8 or 10 mm pipe diameter should be used:
For 50 mbar gas systems, the diameter for gas pipes, hoses and all connecting parts is usually 8 mm.
However, modern vehicles today almost always have a 30 mbar system installed.
At a lower operating pressure of 30 mbar, however, it makes sense to increase the gas volume up to the distribution blocks in order to ensure a sufficient and constant supply to the individual consumers.
In this case, the connection from the gas tank (gas cylinder) to the distribution block must be made using a 10 mm gas pipe.
Please note that the supply from the distribution block to the individual consumers must still be 8 mm in diameter.
Counter plate as a...
Counter plate for gas cylinder wall bracket set 03-050-999
The counter plate was developed for mounting the CAMPKO gas cylinder holder set to enable better fastening of the gas cylinder in the gas box.
Material:
Galvanised steel
Weight: 0,5 kg
Star grip screw with...
Star knob screw with spacer sleeve
(quick release conversion)
Conversion set for the wall bracket (with the 2-fold stainless steel clamping band for an ALUGAS gas cylinder)
2x set of star grip screw with sleeve
Weight: 0.128 kg
Quick-release coupling...
Quick-release coupling with non-return valve
Approved disconnection system for tank gas cylinders to quickly and easily disconnect the tank cylinder in an emergency and to block the gas between the tank nozzle and the filling hose.
(With security element and seal)
Required for G 607 gas test
Weight: 235 g
LPG 90° Flat...
LPG Flat Refuelling - Tank Nozzle with 90° hose connection
Tank nozzle for direct refuelling from the outside of a permanently installed tank gas cylinder system.
With female thread 21.8 for adapter mounting for all country-specific tank guns.
Weight: 222 g
LPG Flat refuelling...
LPG Flat Refuelling - Tank Nozzle
Tank nozzle for direct refuelling from the outside of a permanently installed tank gas cylinder system.
With female thread 21.8 for adapter mounting for all country-specific tank guns.
Weight: 222 g