GasCube Plus Gas detector - Sensor Anaesthetic gas hold-up protection

 
Main sensor incl. additional sensor for even more safety
 

• Warns of propane/butane gas (LPG) and anaesthetic gases
• Optional additional sensors possible
• Optical and acoustic indication of readiness for operation, calibration phase and alarm
• Blue light = ready for operation
• Red light = alarm! (80dB)

GasCube warns of escaping propane/butane gas (LPG) and gases with a narcotic effect.
GasCube is used to warn people in a motorhome or caravan of the risks of escaping gases.
GasCube is permanently installed in the vehicle. The optional additional sensors (cable length 2.7 m) detect the gas concentration in the air just as effectively as the main sensor and bring additional safety in the event of rising and falling gases, which can then enter the room air.
The extremely loud alarm with 80dB reliably wakes you up even when you are asleep.

 
 
Technical data:
 
Central button: ON/OFF
Connection: fixed connection to 12 V on-board power supply
Pressure switch: Ready for operation after 3 minutes
Supply voltage: 12 to 30 volts DC
Acoustic signal: approx. 80 dB
Dimensions in mm: 55 x 87 x 24 mm
Power consumption standby mode: 100 mA
Current consumption alarm: 180 mA
Current consumption of additional sensor: 95 mA
 
Sensor: temperature-controlled sensor that also works reliably above 25°C
Cable length: 2.7m
Sensor diameter 39 mm
 
Mounting: approx. 100 cm above the floor
Dimensions: 55.6 x 86.7 x 24 mm
 
 
Sensitivity:
 
Optional wide-range sensor for LPG gas.
Propane/butane (LPG), narcotic gas = approx. 95 PPM
Optional specific CO gas sensor (carbon monoxide)
Carbon monoxide (CO) = 90 PPM (40 PPM after a few hours of operation)